This is a picture of right after they finished pulling a lateral in. It looks worse than it actually was and looks much better now.

This is the end of a lateral ready for a sprinkler to be attached. You can see the wire and the pipe ready for the swing joint.

In this picture the swing joint is in and the pipe has been blown out.

They put a plastic pipe in around the isolation valves until they pull in the lateral to keep it clean. When they finish they install round plastic boxes over the isolation valve.

This is the sod work on the left collar of one green. They had to go back and fix it after it settled.

While they were doing hole one we had a large snow event that sidelined them for a couple days. Once they could start to finish the install it was rather wet and I have added some pictures of the aftermath.

Hole 1

This is a picture of right after they finished pulling a lateral in. It looks worse than it actually was and looks much better now.

This is the end of a lateral ready for a sprinkler to be attached. You can see the wire and the pipe ready for the swing joint.

In this picture the swing joint is in and the pipe has been blown out.

They put a plastic pipe in around the isolation valves until they pull in the lateral to keep it clean. When they finish they install round plastic boxes over the isolation valve.

This is the sod work on the left collar of one green. They had to go back and fix it after it settled.

Share this page